DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	CAN signal monitoring	Open or poor connector connection in D-CAN High line Open or poor connector connection in D-CAN Low line Open or poor connector connection in D-CAN line Short to power in D-CAN High line (This communication may be possible in the short-circuit and it may not be stored a fault code) Short to power in D-CAN Low line Short to ground in D-CAN High line Short to power in D-CAN Low line (This communication may be possible in the short-circuit and it may not be stored a fault code) Short to each other in D-CAN line Faulty modules that concerned to D-CAN Short to each other and power in D-CAN line Short to each other and ground in D-CAN line Faulty KDS External noise input to the D-CAN line Faulty CAN transceiver Faulty ICU
Enable Condition	Ignition "ON"
Threshold Value	D-CAN BUS off is detected
Diagnosis Time	2s
Symptom	D-CAN communication is not possible
Erase Condition	Erase with KDS after the failure solved