ECM Neutral Mode procedure (With Immobilizer)

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM Neutral Mode" procedure using KDS.
  (Refer to Body Electrical System - "SMART KEY DIAGNOSTIC ")
2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS.
  (Refer to "Body Electrical System - "SMART KEY ")
  
  [If installing a new ECM]
  
  Perform "Key Teaching" procedure using KDS.
  
  (Refer to "Body Electrical System - "SMART KEY ")