April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the CVVT oil control valve connector.
Remove the valves (A) by loosening the mounting bolt.
CVVT oil control valve mounting bolt:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

[Bank 1/Intake]

Courtesy of KIA MOTORS AMERICA, INC.

[Bank 1/Exhaust]

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.

NOTE:

Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Apply engine oil to the valve O-ring.