Component Inspection

1. Connect the KDS on the Data Link Connector (DLC).
2. Turn the ignition switch ON.
3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

   Specification  :

   Accelerator	Output Voltage (V) [Vref = 5.0V]
   Position	APS1	APS2
   C.T	0.7 - 0.8	0.33 - 0.43
   W.O.T	4.13 - 4.22	2.04 - 2.13

*C.T.: Close Throttle

*W.O.T.: Wide Open Throttle