LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 1990 >> Range Rover Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Self-Diagnostic System >> Clearing Diagnostic Trouble Codes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Clearing Diagnostic Trouble Codes

NOTE: Serial link can also be referred to as data link connector or MFI data link connector. Main relay can be also be referred to as fuel injection load relay.

It is necessary to clear code displayed when fault has been rectified to view the following code when more then one code is stored. Clear fault code displayed using following procedure:

  1. Switch ON ignition.
  2. Disconnect White 5-pin serial link connector, wait 5 seconds and reconnect. Serial link connector is located beneath right front seat. See Figure .
  3. Switch OFF ignition, wait for fuel injection load relay to turn off.
  4. Switch ON ignition. The display should now reset. If no other faults exist, and original fault has been rectified, display will be blank. If other faults exist, they will be displayed at this time.
  5. If multiple faults exist, repeat steps  1 - 4 as each fault is cleared the code will change to the next one in order of system priority, until all faults are cleared. See DIAGNOSTIC TROUBLE CODE ORDER OF SYSTEM PRIORITY  table under DIAGNOSTIC TROUBLE CODE DEFINITIONS. The display will now be blank.

scientia non olet · About LEMON Manuals