LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 1995 >> Discovery Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Emission Systems & Sub-Systems >> Fuel Evaporative System Inspection >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Unless there has NEVER been any fuel in system, ensure there are at least 2 gallons of fuel in fuel tank. Disconnect pipe to vapor separator at adsorption canister. Connect pipe to nitrogen cylinder and water manometer using "T" fitting. Pressurize system to 26.5-27.5 In. of water, allow reading to stabilize, then turn off nitrogen supply.
  2. Measure pressure drop within a period of 2.5 minutes. If drop is greater than 2.5 In. of water, system has failed test. Note that a fully sealed system will show a slight increase in pressure. Should system fail test, maintain pressure in system and apply a soap solution around all joints and connections until bubbles appear to reveal source of leak. Repair leak as necessary. Repeat test. Remove test equipment and reconnect pipe to adsorption canister.
scientia non olet · About LEMON Manuals