LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2011 >> LR2 Base >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Anti-Lock Control >> Anti-Lock Control >> Removal And Installation >> Anti-Lock Brake System (Abs) Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Anti-Lock Brake System (Abs) Module: Installation

    All Vehicles 

  1. Install the ABS module.

    Torque: 10 Nm

  2. Install the brake fluid tubes.

    Torque: 15 Nm

  3. Install the battery tray support.

    Torques:

    M6: 10 Nm

    M8: 25 Nm

    4. Left-Hand Drive Vehicles 

  4. Connect the brake booster vacuum line.

    5. All Vehicles 

  5. Install the ECM.
  6. Secure the vacuum line and harness.

    7. Left-Hand Drive Vehicles 

  7. Install the windshield wiper motor and linkage. Refer to WINDSHIELD WIPER MOTOR .

    8. Right-Hand Drive Vehicles 

  8. Install the plenum chamber panel.

    9. All Vehicles 

  9. Install the battery tray. Refer to BATTERY TRAY .
  10. Connect the battery ground cable. Refer to SPECIFICATIONS .
  11. Bleed the brake system. Refer to BRAKE SYSTEM BLEEDING .
  12. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
scientia non olet · About LEMON Manuals