LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> ENGINE (I6 3.2L Petrol) >> Diagnostic Procedures >> Compression Test >> Check The Compression Pressure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check The Compression Pressure

WARNING: Move gear selector lever to 'P' position. Failure to follow this instruction may result in personal injury.
  1. Remove the fuel pump relay.
  2. Start the engine - the engine will start, run for a few seconds then stop.
  3. Remove the spark plugs.
  4. Install the compression tester.
  5. Install an auxiliary starter switch in the starting circuit. With the ignition switch OFF, using the auxiliary starter switch, crank the engine a minimum of five compression strokes and record the highest reading. Note the approximate number of compression strokes required to obtain the highest reading.
  6. Repeat the test on each cylinder, cranking the engine approximately the same number of compression strokes.
  7. Install the removed components in reverse order, observing the specified tightening torques.
  8. Clear all DTCs from the ECM.
scientia non olet · About LEMON Manuals