Electronic Engine Controls (I6 3.2L Petrol): Specifications
| Item | Specification |
|---|---|
| Heated oxygen sensor (H02S) removal* | Apply WD40 or equivalent |
| Heated oxygen sensor (H02S) threads | Apply suitable high temperature anti-seize compound to threads of sensor (Castrol Optimol) |
* Apply to area around sensor threads prior to attempting to remove sensor
GENERAL SPECIFICATION
| Item | Specification |
|---|---|
| Engine management system: | |
| Make | Denso |
| Camshaft position sensor: | |
| Make | Denso |
| Type | MRE (hall affect) |
| Crankshaft position sensor: | |
| Make | Denso |
| Type | Variable reluctance |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft |
|---|---|---|
| Camshaft position (CMP) sensor bolt+ | 10 | 7 |
| Catalyst monitor sensor | 45 | 33 |
| Catalyst monitor sensor harness support bolt | 6 | 5 |
| Crankshaft position (CKP) sensor Torx bolt | 10 | 7 |
| Engine control module (ECM) bracket bolts | 6 | 4 |
| Flywheel sensor bolt | 10 | 7 |
| Flywheel sensor bracket screws | 10 | 7 |
| Fuel rail pressure sensor | 6 | 5 |
| Heated oxygen sensor (H02S)++ | 45 | 33 |
| Knock sensor retaining bolt | 20 | 14 |
| Mass air flow (MAF) sensor Torx screws | 2 | 1 |
+ Apply clean engine oil to a new CMP sensor O-ring seal
++ Apply anti-seize lubricant to threads of sensor - See Lubricants