LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 Base >> Repair and Diagnosis >> General Information >> Reset Procedures >> ATEQ TPMS Reset Procedure >> ATEQ TPMS Reset Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ATEQ TPMS Reset Procedure

NOTE: After any system component replacement or wheel change (i.e., using spare tire), all sensor IDs will automatically program during a drive cycle. A Land Rover T4 may be used if preferred. See manufacturer service information.
  1. Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
  2. The vehicle needs to be stationary for at least 15 minutes.
  3. Drive vehicle for at least 15 minutes at a speed above 18 mph (25 kmh).
  4. After stopping, the vehicle should again remain stationary for at least 15 minutes.
NOTE: If a new sensor is fitted to the spare tire, it must have its identification code programmed into the TPMS diagnostically using a T4 (or a Land Rover-approved diagnostic system), or used on the vehicle as a 'running' wheel and the vehicle then driven for 15 minutes at more than 18 mph (25 km/h).
scientia non olet · About LEMON Manuals