TRAC System

NOTE: Always bleed TRAC system whenever repairs are performed on brake master cylinder or TRAC system.

Remove air cleaner mountings, but DO NOT remove air cleaner assembly from engine. Start engine. Connect bleeder hose to TRAC actuator bleeder plug. Loosen bleeder plug.
CAUTION: Fluid is under high pressure.

NOTE: If fluid does not come out of bleeder plug, loosen flexhose union bolt on accumulator.
Start engine. Operate TRAC pump motor until all air has been bled from fluid. Tighten bleeder plug to specification. See TORQUE SPECIFICATIONS table. Turn engine off. Check fluid level in reservoir. If fluid needs to be added, add fluid with engine running. Check and clear diagnostic code(s).