Throttle Controls: Dashpot
- Start engine, and warm it to operating temperature. Ensure idle speed is correct. Remove cap, filter and separator from dashpot. Increase engine speed, and hold at 2500 RPM.
- Plug small hole in back of dashpot using finger. Release throttle. When throttle is released, engine speed with cooling fan off should be 1500 RPM.
- If necessary, adjust dashpot. When installing separator, filter and cap, install filter with coarse side facing outside.
- Increase engine speed, and hold at 2500 RPM. Release throttle. After a few seconds, engine should return to idle. If dashpot still does not function properly, replace dashpot.