LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1993 >> ES 300 Standard >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Removal & Installation >> Window Motor & Regulator Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Window Motor & Regulator Assembly

NOTE: Power window motor and regulator must be removed as an assembly. Motor can then be replaced separately. Unless otherwise noted, removal and installation procedures for front and rear power window motor and regulator assemblies are similar.
  1. Disconnect negative battery cable. Remove inside door handle bezel. Remove armrest cover. Using taped screwdriver, carefully pry up on the forward end of power window switch assembly, releasing retaining clips. Pull switch panel assembly upward. Unplug switch connector and remove switch assembly.
  2. Remove side ventilator duct. Remove 10 screws and door pocket. Remove armrest base panel and courtesy light. Unplug courtesy light connector. Remove 2 caps and 8 retaining screws. Remove door trim panel. Remove 2 inside door handle links. Remove inside door handle. Remove door speaker assembly.
  3. Remove door inside plate. Remove screws securing window to regulator. Using a shop towel, secure window away from regulator. Unplug power window motor connector. Remove 8 regulator retaining nuts. Remove power window motor and regulator assembly. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals