LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1993 >> SC 300 Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Introduction >> Test Preparation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Preparation

  1. Manufacturer recommends using Check Harness "A" (09990-01000) when using diagnostic code charts to diagnose malfunctions. Check harness "A" is a test harness that is installed between Electronic Control Module (ECM) and ECM connector. Voltage and resistance readings are taken at check harness connectors.
    NOTE: Always check and note diagnostic trouble codes prior to disconnecting ECM connector. Disconnecting ECM connector will erase codes from memory.
  2. To install check harness "A", ensure ignition switch is in the OFF position. Disconnect ECM connector. ECM is located underneath top of passenger-side carpet and is mounted to floor panel. Connect check harness "A" between ECM and ECM connector. Terminal arrangement of check connector is the same as those on the ECM. Proceed to appropriate diagnostic code chart.
scientia non olet · About LEMON Manuals