TRAC Solenoid Relay
- Remove TRAC solenoid relay. Measure voltage between TRAC solenoid relay terminal No. 1 and body ground. If voltage is not 10-14 volts, check and repair harness or connector.
- Check continuity between TRAC solenoid relay terminal No. 2 and ABS/TRAC ECU terminals SAC, SMC and SRC. See TERMINAL IDENTIFICATION table. See Figure. If readings are not 2 ohms, replace TRAC solenoid relay.
TERMINAL IDENTIFICATION
| Application | Connector No. | Terminal No. |
|---|---|---|
| Terminal SAC | A21 | 12 |
| Terminal SMC | A21 | 2 |
| Terminal SRC | A21 | 15 |
| Terminal MTT | A21 | 3 |