LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1994 >> SC 300 Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition System: Distributor: Installation

  1. Install new "O" ring seal to distributor shaft and lightly coat with oil. Align protrusion on drive gear with groove in distributor housing. Insert distributor, aligning stud in cylinder head with center of flange slot. See Fig 1 and Fig 2. Lightly tighten hold-down nut.
  2. Connect spark plug and coil wires to distributor cap. Check ignition timing. See ADJUSTMENTS article in the ENGINE PERFORMANCE section. Tighten distributor hold-down nut to specification. See TORQUE SPECIFICATIONS.
Fig 1: Aligning Distributor Housing & Shaft (1 Of 2 - SC300)
G92C25892Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Aligning Distributor Housing & Shaft (2 Of 2 - SC300)
G92D25893Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals