Engine Controls - Tests W/O Codes: Introduction

Before diagnosing symptoms or intermittent faults, perform steps in appropriate articles;

Use this article to diagnose driveability problems existing when a hard fault code is not present.

NOTE: Some driveability problems may have been corrected by manufacturer with a revised computer control unit. Check with manufacturer for latest computer application.

Symptom checks can direct the technician to malfunctioning component(s) for further diagnosis. A symptom should lead to a specific component, system test or adjustment.

Use intermittent test procedures to locate driveability problems that DO NOT occur when the vehicle is being tested. These test procedures should also be used if a soft (intermittent) trouble code was present, but no problem was found during self-diagnostic testing.

NOTE: For specific testing procedures, see appropriate articles;

For GS300 SYSTEM/COMPONENT TESTS

For SC300 SYSTEM/COMPONENT TESTS

For SC400 SYSTEM/COMPONENT TESTS

For specifications see appropriate articles;

For GS300 ADJUSTMENTS

For SC300 ADJUSTMENTS

For SC400 ADJUSTMENTS

For GS300 SPECIFICATIONS

For SC300 SPECIFICATIONS

For SC400 SPECIFICATIONS