Transmission Pattern Select Switch
Disconnect pattern select switch 7-pin connector (located on center console, behind gear selector lever). Using an ohmmeter, check continuity between specified pattern select switch terminal with switch in specified position. See PATTERN SELECT SWITCH CONTINUITY table. If continuity is not as specified, replace pattern select switch and retest system operation.
PATTERN SELECT SWITCH CONTINUITY
| Switch Position | Terminals No. | Continuity |
|---|---|---|
| PWR | 3 (White/Black Wire) & 7 (Green/White Wire) | Yes |
| NORM | 1 (Green/Red Wire) & 3 (White/Black Wire); 3 (White/Black Wire) & 7 (Green/White Wire) | No |
| SNOW | 1 (Green/Red Wire) & 3 (White/Black Wire) | Yes |