Registration Of Recognition Code
- To begin reprogramming, ensure key is not inserted in ignition switch. Ensure driver's door is open and unlocked, and all other doors are closed. Insert key in ignition switch, then remove it. Go to next step.
- Complete the following in 40 seconds or less: press door lock switch to LOCK position, and then within one second, press door lock switch to UNLOCK position. Repeat procedure continuously until door locks have been locked and unlocked 5 times. Close driver's door, and then open it. Go to next step.
- Complete the following in 40 seconds or less: press door lock switch to LOCK position, and then within one second, press door lock switch to UNLOCK position. Repeat procedure continuously until door locks have been locked and unlocked 5 times. Insert key in ignition switch. To enter desired mode, turn ignition switch to ON position, and then to LOCK position (one cycle) within one second, the specified number of times. See REGISTRATION MODE SELECTION table. Remove key from ignition switch. Go to next step.REGISTRATION MODE SELECTION
Registration Mode No. Of Ignition Switch Cycles Add 1 Rewrite 2 Confirmation 3 Erase 5 - If any mode other than confirmation mode is selected, go to next step. If confirmation mode was selected, door locks will cycle 0-4 times depending on how many transmitter codes are stored in ECU. Example: 2 stored codes = 2 door lock/unlock cycles. Registration of confirmation code is complete after door locks cycle.
- Complete the following in 20 seconds or less: if add mode, rewrite mode or erase mode is selected, to confirm proper initiation, door locks will automatically cycle one time for add mode, 2 times for rewrite mode and 5 times for erase mode. Press new transmitter LOCK and UNLOCK buttons for at least 1.5 seconds, and then within 3 seconds, press any transmitter button for at least one second. Go to next step.
- If within 3 seconds, door locks cycle one time, new transmitter code has been successfully accepted. Go to next step. If door locks cycle 2 times, new transmitter code was not accepted. To program an additional transmitter or to make a second attempt, return to step 5 within 40 seconds.
- Registration of recognition codes is complete under any of the following conditions:
- Forty seconds has elapsed since wireless door lock ECU has responded.
- Driver's door is closed.
- Key is inserted into ignition key cylinder.
- Four recognition codes are registered at one time.