Ignition Timing: Inspection

WARM UP ENGINE
Allow the engine to warm up to normal operating temperature.
CHECK IDLE SPEED (See IDLE SPEED )
CONNECT TIMING LIGHT TO ENGINE
Connect the timing light clip to the black lead wire.

NOTE: Use a timing light that can detect the primary signal.

Fig 1: Connecting Timing Light Clip To Black Lead Wire
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT IGNITION TIMING
1. Using SST, connect terminals TC and CG of the DLC3.
  1. SST 09843-18040
  Fig 2: Connecting Terminals TC And CG Of DLC3
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a timing light, check the ignition timing.
  1. Ignition timing:10 +/- 2° BTDC at idle
  (Transmission in neutral position)
  
  Fig 3: Checking Ignition Timing Using Timing Light
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the SST from the DLC1.
FURTHER CHECK IGNITION TIMING
1. Ignition timing: 6 - 16° BTDC at idle
(Transmission in neutral position)

HINT:

The timing mark moves in a range between 6° and 16°.
DISCONNECT TIMING LIGHT FROM ENGINE