DTC P0606: ECM/Pcm Processor Or DTC P0607: Control Module Performance: Notes
CAUTION:
If ECM replacement is instructed in following testing, always ensure ECM harness connector and ground circuit are okay. If either are suspect, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - LEXUS
article in GENERAL INFORMATION.
NOTE:
For information on engine immobilizer system, see COMPUTERIZED ENGINE CONTROLS
in THEORY & OPERATION article.