Jam Protection Function
WARNING:
Never allow any body part be caught in window when checking jam protection function.
NOTE:
If performing resetting of the limit switch, check after repeating up and down of the glass with automatic operation.
- Confirm that the window will be fully closed with AUTO UP operation.
- Check the operation of the jam protection function.
- Hold the handle of a hammer in the top of window jam. Move up the window with AUTO up operation and check that the window will go down when it touches the handle of the hammer.
- Confirm that the window will then stop going down after about 200 mm.
NOTE:
If removing the glass, glass guide, regulator and etc. be sure to perform the jam protection function check. If the jam protection is not functioning properly, adjust the power window motor reset switch and pulse switch. See POWER WINDOW MOTOR (LIMIT SWITCH & PULSE SWITCH) RESET under ADJUSTMENTS.