Section 331 (Engine Control System): ECM: Replacement
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE GLOVE COMPARTMENT DOOR ASSY (See REPLACEMENT )
- REMOVE ECM
- Disconnect the 5 ECM connectors.
- Remove the 2 nuts and the ECM.
- Remove the 2 screws and the ECM bracket.
- Remove the 2 screws and the ECM bracket No. 2.
- INSTALL ECM
- Install the ECM bracket No. 2 with the 2 screws.
Torque: 3.0 N.m (31 kgf.cm, 27 in.lbf)
- Install the ECM bracket with the 2 screws.
Torque: 3.0 N.m (31 kgf.cm, 27 in.lbf)
- Install the ECM with the 2 nuts.
Torque: 13 N.m (133 kgf.cm, 10 ft.lbf)
- Connect the 5 ECM connectors.
- Install the ECM bracket No. 2 with the 2 screws.
- INSTALL GLOVE COMPARTMENT DOOR ASSY