Manual Close Operation

REMOVE REAR SEAT CUSHION ASSY (See OVERHAUL )
REMOVE REAR SEAT HEADREST PLATE COVER (See OVERHAUL )
REMOVE WIND DEFLECTOR BOARD ASSY (See OVERHAUL )
REMOVE REAR SEAT HEADREST PLATE (See OVERHAUL )
REMOVE REAR SEAT HEADREST ASSY (See OVERHAUL )
REMOVE REAR SEAT BACK ASSY (See OVERHAUL )
REMOVE DOOR SCUFF PLATE ASSY RH (See REPLACEMENT )
REMOVE QUARTER TRIM PANEL ASSY FRONT RH (See REPLACEMENT )
MANUALLY CLOSE QUARTER WINDOW ASSY RH
1. Remove the connector of the power window regulator motor RH.
2. Connect the battery positive terminal to terminal 1 of the connector, and the negative one to terminal 2. Then open the quarter window assy.
  
  Fig 1: Connecting Battery To Terminals 1 & 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
HINT:

On the LH side, connect the battery positive terminal to terminal 2 and the negative one to terminal 1.
INSTALL QUARTER TRIM PANEL ASSY FRONT RH (See REPLACEMENT )
INSTALL DOOR SCUFF PLATE ASSY RH (See REPLACEMENT )
INSTALL REAR SEAT BACK ASSY (See OVERHAUL )
Torque:
- Bolt: 18 N.m (184 kgf.cm, 13 ft.lbf)
- Nut: 7.0 N.m (71 kgf.cm, 63 in.lbf)
INSTALL REAR SEAT HEADREST ASSY
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
INSTALL WIND DEFLECTOR BOARD ASSY
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)