Deceleration Sensor Zero Point Calibration
NOTE:
Perform yaw rate sensor zero point calibration first. See YAW RATE SENSOR ZERO POINT CALIBRATION .
NOTE:
After performing the yaw rate sensor zero point calibration, the VSC warning light goes out. If the vehicle is then driven without programming the deceleration sensor zero point calibration, a malfunction will be detected and the VSC warning light will light up.
- Using Special Tool (09843-18040), connect terminals Ts and CG of DLC3. See Figure.
- Ensure the vehicle is in a stationary condition with the shift lever in "P" position . Turn the ignition switch ON.
- Check that the VSC warning light is lit for about 4 seconds and then starts quick blinking at 0.13 second intervals.
- After ensuring the blinking of the VSC warning light for 2 seconds, turn the ignition switch OFF.
- Remove the special tool.