Inspection Procedure

Fig 1: Checking Wire Harness (Power Window ECU - Battery And Body Ground)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the power window ECU connector.
2. Measure the voltage and resistance according to the value(s) in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   2 (B) - Body ground	Engine switch on (IG)	10 to 14 V

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Condition	Specified Condition
   1 (E) - Body ground	Always	Below 1 Ω

NG: REPAIR OR REPLACE FUSE, HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE