Manual Shifting Test
- PERFORM MANUAL SHIFTING TEST
HINT:
- With this test, it can be determined whether trouble occurs in the electrical circuit. Also, trouble can be a mechanical problem in the transaxle.
- If any abnormalities are found in the following test, the problem is in the transaxle itself.
- Disconnect the TCM connector.
- Drive the vehicle with the TCM disconnected. Shifting the shift lever to; the D position to check whether the shifting condition changes as shown in the table below.SHIFT POSITION AND SHIFTING CONDITION
Shift Position Shifting Condition D No Shift (No Change) HINT:
When driving the vehicle with the TCM disconnected, the gear position will be as follows:
- When the shift lever is in the D position, the transmission will stay in 3rd gear.
- When the shift lever is in the R or P position, the transmission will also be in the R or P position respectively.
- Connect the connector of the TCM.
- Clear the DTC (See DTC CHECK / CLEAR ).