Inspection Procedure

1. Disconnect the transmission control switch connector of the shift lock control unit assembly.
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   VOLTAGE SPECIFICATION
   
   

   Switch Condition	Tester Connection	Specified Condition
   Engine switch on (IG)	3 - Body ground	10 to 14 V
   Engine switch off		Below 1 V

Fig 1: Identifying Transmission Control Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to Next Step 

1. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   5 - Body ground	Below 1 Ω

Fig 2: Identifying Transmission Control Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to Next Step 

1. Measure the resistance between each terminal of the shift lock control unit assembly when the shift lever is moved to each position.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Shift Position	Tester Connection	Specified Condition
   S, "+" and "-"	3 - 7	Below 1 Ω
   Except S, "+" and "-"		10 kΩ or higher
   Press continuously "+" (Up shift)	2 - 5	Below 1 Ω
   S		10 kΩ or higher
   Press continuously "-" (Down shift)	1 - 5	Below 1 Ω
   S		10 kΩ or higher

   Fig 3: Identifying Transmission Control Switch Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE TRANSMISSION CONTROL SWITCH 

OK: Go to Next Step 

1. Connect the transmission control switch connector of the shift lock control unit assembly.
2. Disconnect the A10 ECM connector.
3. Turn the engine switch on (IG), and measure the voltage according to the value(s) in the table below when the shift lever is moved to each position.

   Standard voltage 

   TRANSMISSION CONTROL SWITCH - ECM VOLTAGE SPECIFICATION
   
   

   Shift Position	Tester Connection	Specified Condition
   S, "+" and "-"	A10-25 (S) - Body ground	10 to 14 V
   Except S, "+" and "-"		Below 1 V

   Fig 4: Identifying ECM Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Turn the engine switch off.
5. Disconnect the ECM connector.
6. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

   Standard resistance 

   TRANSMISSION CONTROL SWITCH - ECM RESISTANCE SPECIFICATION
   
   

   Shift Position	Tester Connection	Specified Condition
   Press continuously "+" (Up shift)	A10-16 (SFTU) - Body ground	Below 1 Ω
   S		10 kΩ or higher
   Press continuously (Down shift)	A10-51 (SFTD) - Body ground	Below 1 Ω
   S		10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE