Diagnosis System
- DESCRIPTION
- The defogger system data can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
- CHECK DLC3
- The vehicle uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
Standard voltage
TERMINAL DESCRIPTION SPECIFIED CONDITION CHARTSymbols (Terminal No.) Terminal Description Condition Specified Condition SIL (7) - SG (5) Bus "+" line During transmission Pulse generation BAT (16) - Body ground Battery positive Always 11 to 14 V Standard resistance
TERMINAL DESCRIPTION SPECIFIED CONDITION CHARTSymbols (Terminal No.) Terminal Description Condition Specified Condition CG (4) - Body ground Chassis ground Always Below 1 Ω SG (5) - Body ground Signal ground Always Below 1 Ω CANH (6) - CANL (14) CAN bus line Engine switch off 54 to 67 Ω CANH (6) - Battery positive (+) HIGH-level CAN bus line Engine switch off 1 MΩ or higher CANH (6) - CG (4) HIGH-level CAN bus line Engine switch off 3 MΩ or higher CANL (14) - Battery positive (+) LOW-level CAN bus line Engine switch off 1 MΩ or higher CANL (14) - CG (4) LOW-level CAN bus line Engine switch off 3 MΩ or higher If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
HINT:
Connect the cable of the intelligent tester (with CAN VIM) to the DLC3, turn the engine switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
- If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
- If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.
- The vehicle uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.