Window Defogger Wire: Repair

IF NECESSARY, REPAIR THE DEFOGGER WIRE
1. Clean the broken wire tips with grease, wax and silicone remover.
2. Place the masking tape along both sides of the wire.
  
  Fig 1: Placing Masking Tape On Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Thoroughly mix the repair agent (DuPont paste No. 4817 or equivalent).
4. Using a fine tip brush, apply a small amount of the agent to the wire.
5. After a few minutes, remove the masking tape.
  NOTE: Do not repair the defogger wire again for at least 24 hours.
Fig 2: Applying Amount Of Agent To Wire
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002