Brake Control Power Supply: Installation

1. Install the 2 brackets with the 4 bolts.

   Torque: 13.5 N*m (138 kgf*cm, 10 ft.*lbf) 

2. Install the brake control power supply assembly with the 3 nuts.
   Fig 1: Locating Brake Control Power Supply Assembly With Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 17 N*m (173 kgf*cm, 13 ft.*lbf) 

3. Connect the connector to the brake control power supply assembly.

1. Install the luggage compartment trim cover side RH with the clip.
2. Install the rope hook assembly.

1. Install the luggage compartment trim cover front with the clip.

1. Install the 2 luggage compartment trim No.2 hooks.

1. Install the 2 rope hooks.

1. Install the rear floor finish plate with the clip.

1. Install the 2 rope hook assembly.

1. Install the luggage compartment trim No.1 cover

1. Install the luggage compartment floor mat.

(See DTC CHECK / CLEAR )

(See INITIALIZATION )

Some systems need initialization after reconnecting the cable to the negative battery terminal.