Rear Speed Sensor: Installation

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

CAUTION: When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake fluid pressure may increase.

INSTALL REAR SPEED SENSOR LH
1. Install the sensor with the bolt.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  NOTE: Prevent foreign matter from attaching to the sensor tip.
  
  Fig 1: Locating Speed Sensor Connector And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the sensor connector.
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CHECK SPEED SENSOR SIGNAL
1. Check the speed sensor signal (see TEST MODE PROCEDURE ).