Injector Driver: Installation

INSTALL INJECTOR DRIVER
NOTE:
- Be careful not to drop or strike the injector driver.
- The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.
1. Install the injector driver with the bolt and 2 nuts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 1: Identifying Injector Driver Removing Bolt And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 4 injector driver connectors.
  1. Connect the 3 connectors with wire harness locks and the connector to the injector driver. Move the lock lever in the direction indicated by the arrow to lock the connector.
    NOTE: Connect the connector securely.
    
    Fig 2: Connecting Injector Driver Connectors
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 ENGINE COVER
1. Install the cover with the 3 clips.
2. Connect the 4 connectors.
  
  Fig 3: Locating Cover With Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER INLET
1. Install the air cleaner inlet with the bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 4: Installing Air Cleaner Inlet With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSTALL SERVICE PLUG GRIP (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.