LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GX 470 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle >> Automatic Transmission System >> A/T P Indicator Circuit >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    Fig 1: Identifying P1 Connector Terminals
    G05261298Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Jack up the vehicle.
    2. Disconnect the park/neutral position switch connector.
    3. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    TESTER CONNECTION SPECIFIED CONDITION TABLE

    Shift Position Tester Connection Specified Condition
    P 2 - 6 Below 1 Ω
    Except P ↑ 10 kΩ or higher

    NG: REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 

    OK: Go to Next Step 

  2. INSPECT TRANSFER INDICATOR SWITCH NO. 2 
    Fig 2: Identifying Transfer Indicator Switch No. 2
    G05261251Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the transfer indicator switch No. 2.
    2. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    TESTER CONNECTION SPECIFIED CONDITION TABLE

    Switch Position Tester Connection Specified Condition
    Free 1 - 2 10 kΩ or higher
    Pushed in ↑ Below 1 Ω

    NG: REPLACE TRANSFER INDICATOR SWITCH NO.2 

    OK: Go to Next Step 

  3. INSPECT COMBINATION METER ASSEMBLY 
    1. See the combination meter troubleshooting section (See HOW TO PROCEED WITH TROUBLESHOOTING ).

    NG: REPLACE COMBINATION METER ASSEMBLY 

    OK: REPAIR OR REPLACE HARNESS OR CONNECTOR 

scientia non olet · About LEMON Manuals