LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> GX 470 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle >> Automatic Transmission System >> Pattern Select Switch Circuit >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. CHECK HARNESS AND CONNECTOR (PATTERN SELECT SWITCH - BODY GROUND) 
    Fig 1: Identifying E4 Connector Terminals (1 Of 2)
    G05261294Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the connector of the pattern select switch.
    2. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    TESTER CONNECTION SPECIFIED CONDITION TABLE

    Tester Connection Specified Condition
    4 - Body ground Below 1 Ω

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to Next Step 

  2. INSPECT PATTERN SELECT SWITCH ASSEMBLY 
    Fig 2: Identifying E4 Connector Terminals (2 Of 2)
    G05261295Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    TESTER CONNECTION SPECIFIED CONDITION TABLE

    Switch Condition Tester Connection Specified Condition
    Press continuously pattern select switch (2nd STRT) 3-4 Below 1 Ω
    Release pattern select switch (2nd STRT) ↑ 10 kΩ or higher

    NG: REPLACE PATTERN SELECT SWITCH ASSEMBLY 

    OK: Go to Next Step 

  3. CHECK HARNESS AND CONNECTOR (PATTERN SELECT SWITCH - ECM) 
    1. Connect the connector of the pattern select switch.
      2. Fig 3: Disconnecting ECM Connector
      G05261296Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the ECM connector.
    3. Measure the resistance according to the value (s) in the table below.

    Standard resistance 

    TESTER CONNECTION SPECIFIED CONDITION TABLE

    Switch Condition Tester Connection Specified Condition
    Press continuously pattern select switch (2nd STRT) E8 - 27 (SNWI) - Body ground Below 1 Ω
    Release pattern select switch (2nd STRT) ↑ 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

scientia non olet · About LEMON Manuals