How To Proceed With Troubleshooting

HINT:

• The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT 

2. CUSTOMER PROBLEM ANALYSIS 

   NEXT 

3. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

   NEXT 

4. CONNECT INTELLIGENT TESTER TO DLC3* 

   NEXT 

5. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* 
   1. Refer to the DTC CHECK / CLEAR  .

   NEXT 

6. VISUAL INSPECTION 

   NEXT 

7. SETTING CHECK MODE DIAGNOSIS* 
   1. Refer to the CHECK MODE PROCEDURE  .

   NEXT 

8. PROBLEM SYMPTOM CONFIRMATION 
   1. Refer to the ROAD TEST  .

      Result 

      PROBLEM SYMPTOM RESULT REFERENCE
      
      

      Result	Proceed to
      Symptom does not occur	A
      Symptom occurs	B

   B: GO TO STEP  10

   A: Go to next step. 

9. SYMPTOM SIMULATION 
   1. Refer to the ELECTRONIC CIRCUIT INSPECTION PROCEDURE .

   NEXT 

10. DTC CHECK* 
    1. Refer to the DTC CHECK / CLEAR  .

       Result 

       DTC RESULT REFERENCE
       
       

       Result	Proceed to
       DTC is not output	A
       DTC is output	B

    B: GO TO STEP  18

    A: Go to next step. 

11. BASIC INSPECTION 
    1. Refer to the AUTOMATIC TRANSMISSION FLUID  .
    2. Refer to the PARK/NEUTRAL POSITION SWITCH  .
    3. Refer to the SHIFT LEVER ASSEMBLY  .

    NG: GO TO STEP  21

    OK: Go to next step. 

12. MECHANICAL SYSTEM TEST 
    1. Refer to the MECHANICAL SYSTEM TEST  .

    NG: GO TO STEP  17

    OK: Go to next step. 

13. HYDRAULIC TEST 
    1. Refer to the HYDRAULIC TEST  .

    NG: GO TO STEP  17

    OK: Go to next step. 

14. MANUAL SHIFTING TEST 
    1. Refer to the MANUAL SHIFTING TEST  .

    NG: GO TO STEP  16

    OK: Go to next step. 

15. PROBLEM SYMPTOMS TABLE CHAPTER 1 
    1. Refer to the PROBLEM SYMPTOMS TABLE  .

    NG: GO TO STEP  19

    OK: Go to next step. 

16. PROBLEM SYMPTOMS TABLE CHAPTER 2 
    1. Refer to the PROBLEM SYMPTOMS TABLE  .

    NEXT 

17. PART INSPECTION 

    NEXT: GO TO STEP  21

18. DTC CHART 
    1. Refer to the DIAGNOSTIC TROUBLE CODE CHART  .

    NEXT 

19. CIRCUIT INSPECTION 

    NEXT 

20. IDENTIFICATION OF PROBLEM 

    NEXT 

21. REPAIR OR REPLACE 

    NEXT 

22. CONFIRMATION TEST 

    NEXT: END