DTC B2313 Glass Position Initialization Incomplete: Description
The power window regulator motor assembly is driven by operating the power window switch. The power window regulator motor assembly has motor, regulator and ECU functions.
When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is set.
HINT:
This DTC may occur for all the windows.
NOTE:
- When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
- After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:
- Close the power window by fully pulling up the power window switch and holding it in the AUTO UP position.
- Open the power window by fully pushing down the switch.
Power window regulator motor (for Driver side):
POWER WINDOW REGULATOR MOTOR (FOR DRIVER SIDE)
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2313 |
|
|
Power window regulator motor (for Front passenger side):
POWER WINDOW REGULATOR MOTOR (FOR FRONT PASSENGER SIDE)
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2313 |
|
|
Power window regulator motor (for Rear LH):
POWER WINDOW REGULATOR MOTOR (FOR REAR LH)
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2313 |
|
|
Power window regulator motor (for Rear RH):
POWER WINDOW REGULATOR MOTOR (FOR REAR RH)
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2313 |
|
|