Inspection Procedure

1. Turn the engine switch on (IG) and initialize the power window regulator motor (see INITIALIZATION  ).
2. Turn the engine switch off.
3. Wait for at least 10 seconds, and then turn the engine switch on (IG).
4. Check for DTCs.

   Result: 

   RESULT CHART
   
   

   Result	Proceed to
   B2313 is not output	A
   B2313 output from driver side motor	B
   B2313 output from front passenger side motor	C
   B2313 output from rear motor LH	D
   B2313 output from rear motor RH	E

B: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (See  REMOVAL   ) 

C: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (See  REMOVAL   ) 

D: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (See  REMOVAL   ) 

E: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (See  REMOVAL   ) 

A: END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)