Inspection Procedure

1. Initialize the power window regulator motor assembly.
2. Check if the power window AUTO UP/DOWN function operates normally.

   OK: AUTO UP/DOWN function operates normally. 

NG: END (PROBLEM DUE TO INITIALIZATION FAILURE) 

OK: GO TO NEXT STEP 

1. Check if the jam protection function operates normally for applicable power window.

   HINT:

   The jam protection function does not operate from the fully closed position of the door glass to 4 mm (0.16 in.) below that.

   OK: Jam protection function operates normally. 

   Result: 

   JAM PROTECTION FUNCTION OPERATING RANGE
   
   

   Result	Proceed to
   OK	A
   NG (Front LH side power window)	B
   NG (Front RH side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

B: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (See  REMOVAL   ) 

C: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (See  REMOVAL   ) 

D: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (See  REMOVAL   ) 

E: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (See  REMOVAL   ) 

A: END