Injector Driver: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER INLET COVER (See REMOVAL )
REMOVE ENGINE ROOM SIDE COVER LH (See REMOVAL )
REMOVE ENGINE ROOM SIDE COVER RH (See REMOVAL )
REMOVE NO. 1 AIR CLEANER INLET (See REMOVAL )
REMOVE INTAKE AIR CONNECTOR PIPE (See REMOVAL )
REMOVE AIR CLEANER CAP LH
1. Remove the air cleaner cap LH.
REMOVE AIR CLEANER CAP RH
1. Remove the air cleaner cap RH.
DISCONNECT ENGINE WIRE (See REMOVAL )
REMOVE INJECTOR DRIVER
1. Disconnect the 8 injector driver connectors.
  1. Disconnect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks from the 2 injector drivers.
    HINT:
    
    To release each connector lock, push the claw downward ("Release" in the illustration) and move the lock lever ("Move" in the illustration).
    
    Fig 1: Disconnecting Injector Driver Connectors
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 bolts, 2 nuts and 2 injector drivers with bracket.
  
  Fig 2: Locating Injector Drivers Bracket Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: Be careful not to drop or strike the injector driver.
3. Remove the 8 nuts and 2 injector drivers from the bracket.