VVT Sensor: Installation

INSTALL VVT SENSOR
1. Install the 4 VVT sensors with the 4 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
2. Connect the 4 VVT sensor connectors.
  
  Fig 1: Locating VVT Sensor Connectors And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER ASSEMBLY
1. Install the air cleaner case with the 2 nuts and clip.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
2. Install the element to the air cleaner case.
  
  Fig 2: Locating Air Cleaner Case Clip And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the air cleaner cap to the air cleaner hose assembly with the hose clamp.
  Torque: 3.8 N*m (38 kgf*cm, 34 in.*lbf)
  
  Fig 3: Locating Air Cleaner Cap Hose Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: Insert the protrusion of the air cleaner hose into the hole of the hose clamp.
  
  HINT:
  - The hose clamp can be tightened within the range of 2.0 N*m (20 kgf*cm, 18 in.*lbf) to 5.5 N*m (56 kgf*cm, 49 in.*lbf).
  - When tightening the hose clamp, make sure the hose clamp's end is within the painted white line (width: 2 mm or 0.079 in).
4. Install the air cleaner cap to the air cleaner case with the 2 clips.
5. Connect the MAF meter connector.
INSTALL AIR CLEANER ASSEMBLY LH
1. Install the air cleaner case with the 2 nuts and clip.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 4: Locating Air Cleaner Case Nuts And Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the element to the air cleaner case.
3. Install the air cleaner cap to the air cleaner hose assembly with the hose clamp.
  Torque: 3.8 N*m (38 kgf*cm, 34 in.*lbf)
  
  Fig 5: Locating Air Cleaner Case With Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: Insert the protrusion of the air cleaner hose into the hole of the hose clamp.
  
  HINT:
  - The hose clamp can be tightened within the range of 2.0 N*m (20 kgf*cm, 18 in.*lbf) to 5.5 N*m (56 kgf*cm, 49 in.*lbf).
  - When tightening the hose clamp, make sure the hose clamp's end is within the painted white line (width: 2 mm or 0.079 in).
4. Install the air cleaner cap to the air cleaner case with the 2 clips.
5. Connect the MAF meter connector.
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )