LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Front Acceleration Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Acceleration Sensor: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE INSTRUMENT SIDE PANEL LH  (See REMOVAL )
  4. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING  (See REMOVAL )
  5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See REMOVAL )
  8. REMOVE ACCELERATION SENSOR ASSEMBLY 
    1. Disconnect the sensor connector.
    2. Remove the bolt and acceleration sensor with bracket from the instrument panel reinforcement.
      Fig 1: Identifying Acceleration Sensor
      G04944234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Avoid any impact to the acceleration sensor.
      • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
      • The acceleration sensor removed from the vehicle must not be placed upside down.
scientia non olet · About LEMON Manuals