Height Control Compressor: Installation

Fig 1: Locating Bushings And Bracket
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the 3 bushings and bracket to the height control compressor with the 3 bolts.

   Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf) 

2. Push the connector into the housing until a clicking sound is heard.
3. Attach the 3 clamps.
4. Install the height control sensor with the bolt and 2 nuts.

   Torque: 19.1 N*m (195 kgf*cm, 14 ft.*lbf) 

   Fig 2: Locating Height Control Sensor And Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the height control tube (see SUSPENSION CONTROL SYSTEM  ).
6. Connect the height control filter to the bumper reinforcement.
7. Connect the 2 connectors and attach the 2 clamps.
   Fig 3: Locating Connectors And Clamps

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Perform initialization (see INITIALIZATION ).
   NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).

1. Inspect for air leak (see OPERATION CHECK  ).

1. Install the 2 bolts.

Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)