LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Height Control Compressor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Height Control Compressor: Removal

CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (see SUSPENSION CONTROL SYSTEM  ).
  1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  4. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  7. REMOVE RADIATOR GRILLE ASSEMBLY  (See REMOVAL )
  8. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH  (See REMOVAL )
  9. REMOVE FRONT FENDER WHEEL OPENING MOULDING RH  (See REMOVAL )
  10. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH  (See REMOVAL )
  11. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH  (See REMOVAL )
  12. REMOVE FRONT FENDER LINER LH  (See REMOVAL )
  13. REMOVE FRONT FENDER LINER RH  (See REMOVAL )
  14. REMOVE FRONT BUMPER COVER  (See REMOVAL )
  15. REMOVE FRONT WHEEL RH 
  16. REMOVE FRONT FENDER LINER RH 
    1. Remove the 2 bolts.
    2. Partially remove the fender liner.

      HINT:

      It is not necessary to fully remove the fender liner. Partially remove it so that the compressor can be removed.

  17. REMOVE HEIGHT CONTROL COMPRESSOR 
    1. Disconnect the 2 connectors and detach the 2 clamps.
      Fig 1: Locating Connectors And Clamps
      G04944186Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the height control filter from the front bumper reinforcement.
    3. Disconnect the height control tube (see SUSPENSION CONTROL SYSTEM  ).
    4. Remove the 2 nuts, bolt and height control compressor with bracket.
      Fig 2: Locating Nuts, Bolt And Height Control Compressor With Bracket
      G04944187Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Detach the 3 clamps.
    6. Detach the connector's claw and remove the connector from the bracket.
    7. Remove the 3 bolts, 3 bushings and bracket from the compressor.
      Fig 3: Locating Bolts And Bushings
      G04944188Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals