LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Rear Acceleration Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Acceleration Sensor: Installation

  1. INSTALL ACCELERATION SENSOR ASSEMBLY 
    1. Install the acceleration sensor with bracket with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

      Fig 1: Identifying Acceleration Sensor Assembly
      G04944240Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Avoid any impact to the acceleration sensor.
      • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
    2. Connect the sensor connector.
  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See INSTALLATION )
  3. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT  (See INSTALLATION )
  5. INSTALL LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (w/o Rear Cooler)  (See INSTALLATION )
  6. INSTALL LUGGAGE COMPARTMENT NO. 1 LIGHT ASSEMBLY  (See INSTALLATION )
  7. INSTALL DECK TRIM SIDE BOARD RH  (See INSTALLATION )
  8. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
  9. INSTALL ROPE HOOK  (See INSTALLATION )
  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
  13. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  14. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals