Floor Shift Assembly: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY 
   Fig 1: Locating Transmission Floor Shift Bolts And Wire Harness Clamps

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Install the floor shift with the 4 bolts.

      Torque: 8.3 N*m (85 kgf*cm, 74 in.*lbf) 

   2. Connect the 5 wire harness clamps to the floor shift.
   3. Connect the 2 connectors.
2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
   Fig 2: Locating Floor Shift Gear Shifting Rod Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Temporarily connect the shifting rod to the connecting rod swivel with the nut.

      HINT:

      The nut will be tightened to a torque specification during the shift lever position adjustment procedure.

3. INSTALL NO. 1 CONSOLE BOX DUCT 
   1. Install the duct with the 2 screws.
4. INSTALL CONSOLE BOX ASSEMBLY 
   1. Install the console box (see INSTALLATION ).
5. ADJUST SHIFT LEVER POSITION 
   1. Adjust the shift lever position (see ADJUSTMENT  ).
6. INSPECT SHIFT LEVER POSITION 
   1. Inspect the shift lever position (see ON-VEHICLE INSPECTION  ).
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
8. INSTALL COWL TOP VENTILATOR LOUVER  (See INSTALLATION )
9. PERFORM INITIALIZATION 
   1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.