Rear Speed Sensor: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL REAR SPEED SENSOR LH 
   1. Install the speed sensor with the bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
   2. Install the sensor wire harness to the frame, upper control arm and axle housing with the 6 resin clips.
      NOTE: Do not twist the sensor wire when installing it.
      Fig 1: Locating Speed Sensor Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the clamp bolt to the upper control bracket.

      Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf) 

      NOTE: Do not twist the sensor wire when installing it.
   4. Connect the speed sensor connector.
      NOTE: Do not twist the sensor wire when installing it.
2. INSTALL REAR WHEEL 
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
4. PERFORM INITIALIZATION 
   Fig 2: Locating Speed Sensor Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. CHECK ABS SPEED SENSOR SIGNAL 
   1. Check the ABS speed sensor signal (see DIAGNOSIS SYSTEM  ).