Camshaft Position Sensor: Installation
- INSTALL CAMSHAFT POSITION SENSOR
- Install the camshaft position sensor with the bolt and stud bolt.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
- Install the camshaft position sensor with the bolt and stud bolt.
- INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY BANK 1 (see INSTALLATION )
- CONNECT NO. 1 RADIATOR HOSE (see INSTALLATION )
- INSTALL INTAKE AIR CONNECTOR PIPE (See INSTALLATION )
- INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see
INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see
INITIALIZATION
).
- ADD ENGINE COOLANT (see REPLACEMENT )
- CHECK FOR ENGINE COOLANT LEAKS
- Check for engine coolant leaks (see ON-VEHICLE INSPECTION ).