LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LX 470 >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2UZ-FE) >> Engine Coolant Temperature Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Installation

  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket to the sensor.
    2. Install the sensor.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    3. Connect the sensor connector.
  2. INSTALL THROTTLE BODY (See  INSTALLATION   ) 
  3. INSTALL INTAKE AIR CONNECTOR PIPE (See  INSTALLATION   ) 
  4. INSTALL V-BANK COVER SUB-ASSEMBLY (See  INSTALLATION   ) 
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  6. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  7. ADD ENGINE COOLANT (see  REPLACEMENT  ) 
  8. CHECK FOR ENGINE COOLANT LEAKS 
    1. Check for engine coolant leaks (see ON-VEHICLE INSPECTION ).
      Fig 1: Locating Gasket And Sensor
      G05196924Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals