LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LX 470 >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2UZ-FE) >> Knock Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor: Installation

  1. INSTALL KNOCK CONTROL SENSOR 
    1. Install the 2 knock sensors with the 2 nuts, as shown in the illustration.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    2. Connect the 2 knock sensor connectors.
  2. INSTALL AIR PUMP ASSEMBLY (See  INSTALLATION  ) 
  3. INSTALL INTAKE MANIFOLD ASSEMBLY (see  INSTALLATION  ) 
  4. CONNECT FUEL MAIN HOSE (see  INSTALLATION  ) 
  5. CONNECT FUEL RETURN HOSE (see  INSTALLATION  ) 
  6. INSTALL INTAKE AIR CONNECTOR PIPE (See  INSTALLATION   ) 
  7. INSTALL V-BANK COVER SUB-ASSEMBLY (See  INSTALLATION   ) 
    Fig 1: Identifying Knock Sensor Angle
    G05196939Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  9. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  10. ADD ENGINE COOLANT (see  REPLACEMENT  ) 
  11. CHECK FOR ENGINE COOLANT LEAKS 
    1. Check for engine coolant leaks (see ON-VEHICLE INSPECTION ).
  12. CHECK FOR FUEL LEAKS 
    1. Check for fuel leaks (see ON-VEHICLE INSPECTION ).
scientia non olet · About LEMON Manuals